Electroplating silver spraying method:
Shake the paint well before use, and add it directly to the spray pen without dilution.
It is recommended to use mirror black BC.01X melon seeds · pure black X or SG.06 silicon-based varnish as the base, with a pressure of 0.2MPa~0.3MPa. Ordinary spray pens require higher air pressure, with ultra-small paint output (almost no paint output) and multi-layer thin spraying until the mirror stops. The paint output can be slightly increased with SG.06 as the bottom surface.
After spraying, wait for about 1-2 minutes in a room temperature (25 ℃) environment for the paint surface to dry.
Video reference for silver plating and spraying on Bilibili: BV1Je4y1i7eU
Note: Electroplating silver requires a certain technical threshold for the mirror texture to be sprayed. Electroplating silver is sprayed with oily transparent color. If the technology is not good, electroplating silver may be dispersed by oily varnish. It is necessary to spray multiple layers until the color is in place. When the color is in place, the glossiness will not be high, and subsequent polishing can be applied.
Pseudo electroplating operation video reference Bilibili: BV1E24y1o7c4
If only the electroplating silver effect is needed, that is, after spraying the electroplating silver, SG.06 silicon-based varnish protection can be used.
Spraying SG.06 on MT.01 Operation Video Reference Bilibili: BV1p14y147Xe
Attention: Electroplated silver should not be soaked in water before spraying protective paint, and the environmental humidity should not be too high.